Home > Registration Rejected > Registration Rejected Error Dbconfig

Registration Rejected Error Dbconfig

Contents

If there are any, delete those extensions using the procedure described in CallManager 4.x: Delete Unassigned Directory Numbers Configuration Example. Do they have a TFTP IP? Otherwise, the phone establishes a TCP connection. In fact, its be... http://supercgis.com/registration-rejected/registration-rejected-error-dbconfig-cme.html

I fell into the same issue and finally resolved when I applied utils dbreplication reset command on sub and pub both.You can also check the replication status between pub and sub One Cisco Unified CM group which is listed as Default will appear. Registration Rejected: Error DBConfig Error Message Typically, a Registration Rejected: Error DBConfig message indicates an issue with unassigned directory numbers (DNs). Error DBConfig? http://www.cisco.com/c/en/us/support/docs/voice-unified-communications/unified-communications-manager-callmanager/96102-registrationrejectederrordbco.html

Cisco 7940 Registration Rejected

The wood and paper industry plants 1.7 million new trees EVERY DAY _____ From: Samme-Nlar Tomslin [mailto:tsammenlar [at] sevenseastech] Sent: Friday, March 26, 2010 11:10 AM To: sasanka.pathi Cc: Carter, Bill; Cisco 7941G IP Phone: Registration Rejected: Error... The wood and paper industry plants 1.7 million new trees EVERY DAY _____ From: Samme-Nlar Tomslin [mailto:tsammenlar [at] sevenseastech] Sent: Friday, March 26, 2010 11:10 AM To: sasanka.pathi Cc: Carter, Bill; Jonathan On Wed, Aug 6, 2008 at 8:59 AM, Jeff Cartier <jcartier [at] acs> wrote: I'm having the weirdest time trying to get two phones to register…one is a 7941 and

But always I am getting "Registration rejected: error Dbconfig " Auto registration enabled for the tftp server. Related Information Troubleshooting Cisco IP Phone (7910, 7940, 7960, 12 SP, and 30 VIP) Registration Problems with Cisco CallManager 3.x and 4.0 Voice Technology Support Voice and Unified Communications Product Support Are the phones getting an IP address? Cucm 10.5 Registration Rejected Use Auto-registration if you want Cisco Unified CM to automatically assign directory numbers to new phones when you plug these phones in to your network.

Subnet Mask Cheatsheet Cisco Switch QoS: 12.2(40) IOS And 'auto qos' Thou... ► October (12) ► September (26) ► August (31) ► July (30) ► June (21) ► May (23) ► Registration Rejected Error Mismatch Magic Mac Address: What To Do When You Have Multiple Check Point Clusters On The Same Subnet OR In Parallel With Each Other (NOTE*** Please read through this whole posting. I don't know why things get hung up but resetting many times clears al of things up quick. Get More Information It's okay!

Yes No Feedback Let Us Help Open a Support Case (Requires a Cisco Service Contract) Related Support Community Discussions This Document Applies to These Products Unified Communications Manager (CallManager) Unified IP Cisco 7841 Registration Rejected It's okay! It appears as the IP address of the servers group at the beginning of the file. From: cisco-voip-bounces [at] puck [mailto:cisco-voip-bounces [at] puck] On Behalf Of Jonathan Charles Sent: Wednesday, August 06, 2008 10:05 AM To: Jeff Cartier Cc: cisco-voip [at] puck Subject: Re: [cisco-voip] 7961 &

Registration Rejected Error Mismatch

skeaf2013 likes this Back to top Report Thanked by 1 Member: skeaf2013 #10 skeaf2013 skeaf2013 Member Members 17 posts 0 thanks Posted 29 January 2015 - 09:40 AM Hi Also keep in mind that content or views contained herein are expressly the views of myself or the individual contributor and are not the views of mine or any contributor's employer. Cisco 7940 Registration Rejected I'm not sure what I'm doing wrong...any chance anyone can maybe send me a scratch (base configuration) so I can compare and see what I'm missing? _______________________________________________ cisco-voip mailing list cisco-voip Cucm Phone Status Rejected Cisco Router: How Do You See The Bandwidth Utiliza...

I have recently had a Cisco 7941G IP phone that I needed to add for my own remote office setup. http://supercgis.com/registration-rejected/registration-rejected-dbconfig-error.html Depending on your specific network configuration, not all of these steps may occur on your Cisco Unified IP Phone. Auto-registration Auto-registration automatically assigns directory numbers to new devices as they connect to the IP telephony network. Have u done any firmware up gradation. Cisco 7945 Registration Rejected Error Mismatch

From:cisco-voip-bounces [at] puck [mailto:cisco-voip-bounces [at] puck] On Behalf Of Jonathan Charles Sent: Wednesday, August 06, 2008 10:05 AM To: Jeff Cartier Cc: cisco-voip [at] puck Subject: Re: [cisco-voip] 7961 & 7941: telephony-service no auto-reg-ephone load 7941 SCCP41.8-3-3S load 7961 SCCP41.8-3-3S do you have ephone's created with type of 7941 or 7961? Posts: 213 | From: Hong Kong | Registered: Apr 2008 | IP: Logged Angel Perez Elite Member # 28233 Member Rated: posted October 19, 2009 08:18 AM http://supercgis.com/registration-rejected/registration-error-dbconfig-rejected.html Error DBConfig?

Registration Rejected This means that your IP Phone has already gone through the Phone Boot process and is stuck at step #6,  attempting to register to either the Pub or Sub, Troubleshooting Cisco Ip Phone Registration Problems If so, install Cisco Phone firmware load 8.5(2). If this fail the IP Phone continues down the list until it is able to register Now that we under stand the IP Phone Boot process, what else does TFTP do?

I can verify that's its getting all the proper DHCP/TFTP/CME information....and it's a CME.....SCCP Here's a debug of 'tftp events' Aug 6 14:14:18.627: TFTP: Looking for SEP001F9EABEAF2.cnf.xml Aug 6 14:14:18.631: TFTP:

Is > auto-registration enabled? > > > > Jonathan > > On Wed, Aug 6, 2008 at 8:59 AM, Jeff Cartier <jcartier [at] acs> wrote: > > I'm having the weirdest telephony-service load 7912 CP7912080003SCCP070409A load 7921 CP7921G-1.1.1 load 7960-7940 P00308000500 load 7941 SCCP41.8-3-3S load 7961 SCCP41.8-3-3S ephone 7 device-security-mode authenticated capf-auth-str 2734 cert-oper upgrade auth-mode auth-string mac-address 001F.9EAB.EAF2 username "jp" type Do they have a TFTP IP? Cisco 8851 Registration Rejected Do they have a TFTP IP?

Is auto-registration enabled? And also If possible kindly give the details of the Firmware version of the IP phones Warm Regards, Venkata Sasanka.pathi(-91 950 265 2290) Consultant | unified communications Locuz Enterprise Solutions Ltd. Note: If this is not configured the SIP Phone will use the time-stamp from the 200 OK message for its time.  This is a fallback mechanism SCCP Phones get there time this contact form Brocade ICX 6430-24: An Initial Configuration To Get Started When Im doing a lot of switches, I usually like to put it all in notepad and get it ready for cut

Which? Posts: 83 | From: Russia | Registered: Feb 2009 | IP: Logged Angel Perez Elite Member # 28233 Member Rated: posted November 15, 2009 11:02 PM It should end with cop.sgn . 4) Try doing manual registration of 1 phone and try auto-registration. 5) If there are any phones working download the firmware of that working phones If you are not the intended addressee, you are hereby notified that you have received this communication in error and that any use or reproduction of this email or its contents

The IP Phone now understand what VLAN to use 3rd – The IP Phone now sends a DHCP request asking for an IP Address on its VOICE VLAN.  This request is Related Information IP Phone Error Message - Registration Rejected: Error DBConfig Voice Technology Support Voice and Unified Communications Product Support Troubleshooting Cisco IP Telephony Technical Support & Documentation - Cisco Systems Friends & links Discuss Get Inspired Get Polling Get Support Learn WordPress.com WordPress Planet WordPress.com News Pages About Monthly archives January 2011 Blog at WordPress.com. [ Back to top ] Network Paste this in: telephony-service ip source-address 172.31.254.2 port 2000 create cnf-files reset all That will fix it and reset all your phones Jonathan On Wed, Aug 6, 2008 at 10:30 AM,

From: cisco-voip-bounces [at] puck [mailto:cisco-voip-bounces [at] puck] On Behalf Of Ryan West Sent: Wednesday, August 06, 2008 10:11 AM To: Jonathan Charles; Jeff Cartier Cc: cisco-voip [at] puck Subject: Re: [cisco-voip] It seemed to have fixed the 7941 phone, but not the 7961 phone. I am trying to register my communicator with CCM.